Nickel Wurks Yamaha YZ YZF Bolt Kit

(No reviews yet) Write a Review

All New YAMAHA YZ Nickel Wurks Dress-Up Bolt kit!

This high quality Nickel Wurks bolt kit is for all...

YAMAHA YZ 65 80 85 125 250 400 465 490 500


This kit uses 10.9 grade nickel plated fasteners. They are all designed with performance in mind. Configured to bring your YAMAHA YZ to WURKS status using only the best fasteners.

Includes our exclusive Yamaha collection of Blue anodized Factory Yamaha CNC bodywork bushings.

Is this enough to completely restore my bike? No its not. But its enough to bling the bike out, Big Time. If you need more to complete your project, its easy to find the sizes you want right here on the site under our "Nickel Wurks Series" hardware category. Additional sizes up to 100mm long available separately here on the site for about buck a bolt.

Kit Includes:

Full set of modern Fork Guard bolts

6 Nickel wide head radiator shroud bolts

Nickel seat bolts

2 correct square nuts for rear fender

A full Nickel Sprocket bolt kit

Plastics fender & body bolts

Fender washers

Most visible engine side cover bolts

Radiator bolts

Shifter bolt

Flange Nuts for cylinder and head

Exhaust bolts

Most triple clamp and handlebar clamp bolts

Front axle pinch bolts

Front brake caliper bolts

Fuel tank bolts

Clutch and front brake perch bolts

Number plate and side panel bolts

...all with a hard and beautiful nickel finish.

More Information:

We give you our full assortment of Yamaha blue anodized CNC bushings that are used all over these motorcycles.

You get a huge assortment of M5, M6, and M8 Nickel Wurks bolts. Nearly enough to replace all your bike's engine covers, triple clamps, bar clamps, front brake caliper, front axle pinch bolts, body plastics, radiator bolts, chain slider, swingarm components.

Additional bolts may be needed depending on your make and model. These are all available as refills in our specbolt website store for around a buck a bolt.

M6 Nickel Wurks flange bolts in this kit range in size from M6x10 up to M6x45 and look beautiful used on your engine covers and plastics. M8 Nickel Wurks flange bolts in this kit range in size from M8x12 up to M8x45 and are perfect to replace your old bolts on your seat, front end, triple-clamps, bar mounts, axle pinch bolts, brake caliper mounts etc...

M6 Nickel Wurks wide head flange bolts in this kit in 2 sizes. M6x12 & M6x16 and are great for mounting radiator shrouds and bodywork plastics.

Our OEM exact match Specbolt Collar washers and bushings are perfect size and for mounting plastics and bodywork. These allow body bolts to be fully tightened and greatly reduce the chance of splitting your plastic while tightening. We give you 2 each of the 3 sizes of hard to find oval CNC bushings only available previously from Yamaha.

This kit contains a full assortment of Nickel Plated Flange nuts in M6, M8, and M10 sizes. An assortment of the most needed Fender and Flat Washers are included.

A Full set of Yamaha Sprocket Bolts with thread lock pre-applied and matching flat washers and class 10 flange bolts.

A full set of 6 Yamaha specific Fork Guard Bolts are included in the set. A big improvement over stock. They have been re-engineered to hold the fork guards a little firmer in place and eliminate any wiggle found on some models. This is especially helpful when running a holeshot device